Archive: June 14, 2025

incinerator sort of pyrolytic medical waste incinerator ability

Including:Incinerator: Structure to be specified
The mark to be specified
Water temperature: 800 to 1000 ° C;
Refractory
Temperature of more than 1100 ° C + obtained;
Capacity: 20-50 kg / hour
Fireplace: 4 to 6 meters high;
Dimension 70 cmx70 crn
Height: 1.10 meters
Fuel: coal;
Aspiration: natural

– A receiving cage for biomedical waste;

– A combustion chamber with a chimney with a filter to retain the ashes;

Chimney section: about 300 cm; With a minimum height of 6 m

Door size: approximately 50×60 cm

Supplied with a 500 liters fuel tank and all necessary accessories for installation.
–                          INCINERATOR for pharmaceutical waste treatment with                  a scrubbing system

With the following technical data:

1.      One pharma solid waste incinerator unit containing two combustion chambers and based on steel base with scrubbing

system.

2.      Working hour /day: minimum 10 hours/day.

3.      Capacity: Approximated 150 kg/hr. Over 10 hrs.

4.      Wastes characteristics:

·         BULK density: 70 – 100 kg/ bm³.

·         Calorific value: 2000-3000 kcal / hr.

·         Moisture content: 20-30%by weight.

·         Ash content: 2 – 8 % by weight.

·         Plastic content: 15-20 % by weight.

5.      Two combustion chambers.

6.      Operating temperatures:

·         First chamber: not less than 700 – 800 °c.

·         Second chamber: not less than 1200 °c (during steady operation).

7.      The burners should be automatically switched off if any of the combustion chambers doors is open.

8.      The burners of the first and second combustion chambers are selected for burning diesel oil (light fuel).

9.      Automatic loader and unloader to be provided.

10.     Exhaust gases to be comply with International Environmental code and requirements.

lab incinerator china manufacturer

Incinerator double chamber with ability 1.5 m3/batch or 6 m3/ day, electronic thermocontrol range 0‐1200

C, thermocouple, air supply capacity 10m3/ minute, power usage 1.2 kWH/ hour, power 3

stage with netral, cooling water sprinkler capacity 5L/ minute, finished with refractory (insulation,

castable, ceramic covering) and PLC

SUPPLY, INSTALLATION As Well As COMMISSIONING OF WASTE BURNER– TECHNICAL SPECS

The Waste Incinerator is created to burn Type IV of pathological waste as well as contagious, infected “red bag,” surgical

dressings, plastic examination devices and also various other wastes.
General Specs
Burner: 2 heaters (primary heater as well as second heater).
Fuel: Oil.
Capacity (Cubic Mtr): 0.65.
Ave Capacity: 60 kg per hour.
Gas Intake (ltrs/ hr):13.
Outside Dimensions.
Size (mm): 2300.
Size (mm): 1220.
Elevation Incl. Flue (mm) 7000.
Door Opening (mm) 610 x 710 610 x 710.
Operation.
Minutes. Operating Temperature level: 950.
Max. Operating Temperature: 1320.
Residency Time in Second Chamber: 5 sec.
Temperature Level Monitoring: YES.
Various other information.
Easy and safe operation.
Huge counter-balanced fill door with electrical lockout.
Automatic control system gives preset melt times and shut down.
Reload light indicates to driver when it is time to reenergize.
Be required for exhaustion of last charge.
Low power usage degrees.
Programmable electronic temperature controls preserve temperature level, assuring complete combustion while conserving fuel.
Stress blower with regulating air control creates disturbance as well as disperses burning air to additional chamber.
Second heater with temperature triggered modulating control offers fast preheat and sustains high temperature

efficiency at low power usage degrees.
Charging price

hospital incinerator supplier

Up to 600kgs per ten-hour day of Kind IV pathological waste or red bag waste rated at 2200 BTU’s per kg, based on batch

packing twice daily.
Burner, 20 kg/hr Burn Ability (min. 1200 kgs. Waste Feed Ability each day) (4-6 hrs procedures) (Power Supply

380V, 50Hz, 3Ph).
Capacity: 30 kg/hr.

Number product: 01 system

Can you please send us cataloge information for Pet Cremation of dogs, pet cats.

– – Please services call for: General concerning Cremation system which is suitable.
for your items, technical transfer and also training for operators.
Containerized Incinerators Operational Capabilities – PROCEDURE 1+ TONS/ DAY – RAN WITH LIMITED TRAINING – REGULAR

MAINTENANCE CONTAINER BE FINISHED WITH RESTRICTED TRAINING – COMPLIES WITH EURO/ OR US-EPA DISCHARGE REQUIREMENTS – CAPABILITY TO MELT

SQUANDERED LUBRICANTS (POL) – HANDLE ORGANIC SOLIDS (TO CONSIST OF RMW) – DEPLOYABLE – MOBILE – 24 HUMANS RESOURCES OF CONTINUOUS USE –

AUTOMATIC LOADING SYSTEM – AUTOMATED ASH REMOVAL SYSTEM – GAS SCRUBBING SYSTEM – 95% DECREASE OF SOLID WASTE – RUN

OFF DIESEL OR FUEL OIL – EFFICIENT IN BURNING 4 DEVICES OF WASTE EACH OF GAS – ABLE TO TAKE ALL COMBUSTIBLE WASTE TO

INCLUDE: PAPER, PLASTIC, CARDBOARD, FOOD, USED OILS, SLUDGE, OILY RAGS, TIMBER PALLETS. – NO PRE-TREATMENT OF WASTE

REQUIRED – VENDOR REPAIR WORK OFFERED AT FACTOR OF SHIPMENT – 5 (5) YEAR ELEMENT SERVICE WARRANTY FROM DATE OF ACCEPTANCE

Technical Requirements – PROCEDURE GUIDEBOOK As Well As TRAINING MANUAL FOR EACH INCINERATOR – ESTABLISH As Well As SETUP

USER’S MANUAL – BLUE PRINT/ SCHEMATIC OFFERED THAT DETAILS THE PHY SICAL CAPACITIES OF THE 20′ INCINERATORS –

INCINERATORS MADE UP WITH HEAVY DUTY BONDED BUILDING – OPERATED AND ALSO CARRIED IN 20′ INCINERATORS (CONTAINERS) –

FULL FRONT As Well As OPTIONAL REAR GAIN ACCESS TO – PRIMARY/ SECONDARY TEMPERATURE MANAGES – COMBUSTION AIR DAMPER – VAPOR LIMITED

LIGHT FIXTURES & & 120V ELECTRICAL OUTLET – OUTDOOR PLU-IN RECEPTABLE FOR ELECTRICAL RESOURCE – OUTDOOR FUEL TRAIN WITH SHUT-OFF – LOAD

RAMP – SKID– PLACED GAS TANK – ELECTRICAL AND GAS OIL CONNECTORS – CONTROL PANEL As Well As AIR LOUVER – AIR MANIFOLD

ACCESS As Well As ENERGY BULKHEAD – GALVANIZED DELIVERY COVERS – GAS, WATER As Well As OIL ADAPTER LINES – PRIMARY AND SECONDARY

BURNERS – FULLY INTEGRATED PLC CONTROL SYSTEM – FACTORY EXAMINED, WIRED PRIOR TO DELIVERY – FLEXIBILITY: NO HEAVY LIFT

DEVICES NEEDED FOR SET UP OR TAKE DOWN – HEIGHT RESTRICTED TO THE HIGHEST POINT ON BASE OR UNDER 15FT HIGH